I'm sure I remember reading somewhere that it is possible to have both
EWF and FBWF on the same system as long as only one is active at a time.

I added both components to my image with their "start" check boxes unchecked
and enabled FBWF at the point of creating my recovery image.

This works fine in so far as FBWF starts enabled on the next boot.

My problem is that if I then disable FBWF, and reboot, it is not possible
to enable EWF. "EWFMGR c:" reports "Failed getting protected volume
configuration with error 1". My EWF component was set to Ram (Reg) in TD.

Any ideas?

--
- Mike