Type IPCONFIG /ALL into a cmd box. (Run...cmd)

Check that the default gateway and DNS server addresses are correct. If not
type:

IPCONFIG /RELEASE

then

IPCONFIG /RENEW

If this does not correct them , try using a manually-set IP address. Gateway
and DNS are normally the router's IP.

Also, this may possibly be the problem:
http://mylogon.net/support/psave

--------------------------
"This is a wonderful computer. It''s 20yrs old and absolutely reliable.
And, in all that time it''s only had four mobos, six processors, two cases,
seven OS''s ...."


"Zoghrob" wrote:

> I just clean installed Windows XP SP2 yesterday.
> Typically after installation I let the windows update I& no problem so far,
> after a while I was told to install SP3, I did & as far as I remember no
> problem so far.
> I was then told to update & install few security fixes & issues which I did
> too.
> Just after that eacj time I start my system I can't access the web (no
> matter IE7, or firefox) though my router is on & connected & network
> connection shows connected with correct parameters, I must disable then
> enable my network connection to be abloe to access the web (it takes kong
> time acquiring address, unlike before).
> Actually I feels its a problem with 1 of the last updates, but which 1?
> How can I solve this issue?
> My system configuration is :
> P4 3.0 GHZ, Motherboard Gigabyte 945 (with 10/100/1000 lan integrated), 2GB
> RAM
> Thanks & looking for your reply.