windows did not start successfully

I keep receiving the above message everytime i start my computer. when I
follow the instructions and click on safe mode, I am sent to a blue screen
telling me that "A problem has been detected and windows has been shut down
to prevent damage to your computer."

Unfortunenately this is as far as I get. I also get an error Message at the
bottom of the screen: "***STOP: 0X00000050(0XC3340000,
0X00000000,0X804DADF8,0X00000000). It also states to restart the computer and
hit F8 and then select safe mode. But every time I come back to the Blue
Screen and I am frozen at the at point every time. i need help fast.

Have a look here..
http://aumha.org/a/stop.htm

"dietramone" <dietramone@discussions.microsoft.com> wrote in message
news:35BF5D86-646F-47A0-BD9D-ED27260CEC92@microsoft.com...
>I keep receiving the above message everytime i start my computer. when I
> follow the instructions and click on safe mode, I am sent to a blue screen
> telling me that "A problem has been detected and windows has been shut
> down
> to prevent damage to your computer."
>
> Unfortunenately this is as far as I get. I also get an error Message at
> the
> bottom of the screen: "***STOP: 0X00000050(0XC3340000,
> 0X00000000,0X804DADF8,0X00000000). It also states to restart the computer
> and
> hit F8 and then select safe mode. But every time I come back to the Blue
> Screen and I am frozen at the at point every time. i need help fast.

Thanks to http://www.aumha.org/a/stop.php I would open the computer
and remove the Ram Memory Sticks and Reseat them if you are so inclined. If
you have more than one, try one stick and then the other. Unless it;s a
paired set.
Make sure that the power is disconnected from the wall or surge protector
before proceeding.
0x00000050: PAGE_FAULT_IN_NONPAGED_AREA
(Click to consult the online MSDN article.)
Requested data was not in memory. An invalid system memory address was
referenced. Defective memory (including main memory, L2 RAM cache, video
RAM) or incompatible software (including remote control and antivirus
software) might cause this Stop message, as may other hardware problems
(e.g., incorrect SCSI termination or a flawed PCI card). Use the General
Troubleshooting of STOP Messages checklist above.
a.. You receive a Stop 0x00000050 error on a Blue Screen {KB 894278} Win
2000, Win XP, Server 2003 (with concurrent 1003/System entry in Event
Viewer: possible Rootkit spyware infestation)
b.. Possible Resolutions to STOP 0x0A, 0x01E, and 0x50 Errors {KB 183169}
Win NT, Win 2000, Win XP
c.. During setup {KB 171003} Win NT, Win 2000, Win XP
d.. Easy CD Creator 5.0 Does Not Function In Windows XP {KB 310628} Win XP
e.. How to Use Driver Verifier to Troubleshoot Windows Drivers {KB 244617}
Win 2000, Win XP, Server 2003
f.. STOP Error When You Start Windows After You Connect a Scanner {KB
310869} Win XP
g.. Stop 0x1E in PROTCLS.SYS When You Undock a Toshiba Tecra 8100 {KB
284154} Win XP
h.. STOP 0x4E, STOP 0x1A, STOP 0x50, and STOP 0xA Errors Occur When You
Try to Start the Computer {KB 271955} Win NT 4.0 (corrupt physical RAM)
i.. "STOP 0x00000050" Error Message in Stac97.sys After You Upgrade Your
Panasonic Toughbook to Win XP Service Pack 1 {KB 329832} Win XP SP1










"dietramone" <dietramone@discussions.microsoft.com> wrote in message
news:35BF5D86-646F-47A0-BD9D-ED27260CEC92@microsoft.com...
>I keep receiving the above message everytime i start my computer. when I
> follow the instructions and click on safe mode, I am sent to a blue screen
> telling me that "A problem has been detected and windows has been shut
> down
> to prevent damage to your computer."
>
> Unfortunenately this is as far as I get. I also get an error Message at
> the
> bottom of the screen: "***STOP: 0X00000050(0XC3340000,
> 0X00000000,0X804DADF8,0X00000000). It also states to restart the computer
> and
> hit F8 and then select safe mode. But every time I come back to the Blue
> Screen and I am frozen at the at point every time. i need help fast.

I would to try every thing you are telling me, but I can't even get passed
the blue screen after turning on my computer. I have turned off several times
since yesterday. and still I go to the blue screen.

"Rich Barry" wrote:

> Thanks to http://www.aumha.org/a/stop.php I would open the computer
> and remove the Ram Memory Sticks and Reseat them if you are so inclined. If
> you have more than one, try one stick and then the other. Unless it;s a
> paired set.
> Make sure that the power is disconnected from the wall or surge protector
> before proceeding.
> 0x00000050: PAGE_FAULT_IN_NONPAGED_AREA
> (Click to consult the online MSDN article.)
> Requested data was not in memory. An invalid system memory address was
> referenced. Defective memory (including main memory, L2 RAM cache, video
> RAM) or incompatible software (including remote control and antivirus
> software) might cause this Stop message, as may other hardware problems
> (e.g., incorrect SCSI termination or a flawed PCI card). Use the General
> Troubleshooting of STOP Messages checklist above.
> a.. You receive a Stop 0x00000050 error on a Blue Screen {KB 894278} Win
> 2000, Win XP, Server 2003 (with concurrent 1003/System entry in Event
> Viewer: possible Rootkit spyware infestation)
> b.. Possible Resolutions to STOP 0x0A, 0x01E, and 0x50 Errors {KB 183169}
> Win NT, Win 2000, Win XP
> c.. During setup {KB 171003} Win NT, Win 2000, Win XP
> d.. Easy CD Creator 5.0 Does Not Function In Windows XP {KB 310628} Win XP
> e.. How to Use Driver Verifier to Troubleshoot Windows Drivers {KB 244617}
> Win 2000, Win XP, Server 2003
> f.. STOP Error When You Start Windows After You Connect a Scanner {KB
> 310869} Win XP
> g.. Stop 0x1E in PROTCLS.SYS When You Undock a Toshiba Tecra 8100 {KB
> 284154} Win XP
> h.. STOP 0x4E, STOP 0x1A, STOP 0x50, and STOP 0xA Errors Occur When You
> Try to Start the Computer {KB 271955} Win NT 4.0 (corrupt physical RAM)
> i.. "STOP 0x00000050" Error Message in Stac97.sys After You Upgrade Your
> Panasonic Toughbook to Win XP Service Pack 1 {KB 329832} Win XP SP1
>
>
>
>
>
>
>
>
>
>
> "dietramone" <dietramone@discussions.microsoft.com> wrote in message
> news:35BF5D86-646F-47A0-BD9D-ED27260CEC92@microsoft.com...
> >I keep receiving the above message everytime i start my computer. when I
> > follow the instructions and click on safe mode, I am sent to a blue screen
> > telling me that "A problem has been detected and windows has been shut
> > down
> > to prevent damage to your computer."
> >
> > Unfortunenately this is as far as I get. I also get an error Message at
> > the
> > bottom of the screen: "***STOP: 0X00000050(0XC3340000,
> > 0X00000000,0X804DADF8,0X00000000). It also states to restart the computer
> > and
> > hit F8 and then select safe mode. But every time I come back to the Blue
> > Screen and I am frozen at the at point every time. i need help fast.
>
>
>

On May 6, 9:32*pm, dietramone <dietram...@discussions.microsoft.com>
wrote:
> Unfortunenately this is as far as I get. I also get an error Message at the
> bottom of the screen: "***STOP: 0X00000050(0XC3340000,
> 0X00000000,0X804DADF8,0X00000000).

Software has attempted to access forbidden memory locations. Code
at 0X804DADF8 has attempted to read from 0XC3340000. So learn what
software in that memory location is trying to do illegal reading.

Meanwhile, the stop code screen would have more information.
Without that information, no one can provide a useful answer.

We know this much - the problem is with Operating System files,
hardware drivers, defective hardware that has confused it associated
software driver, defective memory that has changed its data, or even a
power supply voltage that has been defective for months and finally
causing failures.

Follow the evidence. But that means the entire blue screen error
message must be posted - especially every letter and number that means
nothing to you.

While awaiting a next reply, your problem is why responsible
computer manufacturers provide comprehensive hardware diagnostics to
verify all relevant hardware AND that do not complicate a solution
with Windows. Find and execute them. At this point, nobody knows
which way to look - left or right - software or hardware - since both
can cause your failure.

"dietramone" wrote:

> I keep receiving the above message everytime i start my computer. when I
> follow the instructions and click on safe mode, I am sent to a blue screen
> telling me that "A problem has been detected and windows has been shut down
> to prevent damage to your computer."
>
> Unfortunenately this is as far as I get. I also get an error Message at the
> bottom of the screen: "***STOP: 0X00000050(0XC3340000,
> 0X00000000,0X804DADF8,0X00000000). It also states to restart the computer and
> hit F8 and then select safe mode. But every time I come back to the Blue
> Screen and I am frozen at the at point every time. i need help fast.